Genelec 8320APM-6 SAM Studiomonitori tummanharmaa
Genelec 8320A SAM™ Studio Monitor Dark Grey
Compact enough to fit into the tightest of spaces - yet intelligent enough to adapt to your recording environment - the 8320A is your entry point into the world of Smart Active Monitoring.
Transparent and truthful
The 8320A provides transparent and truthful reproduction, and with its wide uncoloured sweet spot you are always in a position to make accurate, reliable mix decisions. The recycled aluminium design of it rear-ported enclosure not only provides staggering LF extension from such a compact unit, its curved form and integrated waveguide guarantees precise, detailed performance both on and off axis.
Compact but clever
As a Smart Active Monitor, the 8320A integrates closely with our GLM software via which it can be configured and calibrated for your listening environment, compensating for detrimental room influences to create a truly optimised monitoring solution from mono to immersive. So whether you work in challenging acoustic spaces or need a mobile solution that can quickly adapt to different rooms, the 8320A is your compact but clever monitoring companion.
1 x 8320A monitor
1 x mains cable 1,8 m
1 x RJ45 cable 5 m
1 x operating manual
Technical Specifications
System Specifications
Frequency Response
66 Hz - 20 kHz (± 1.5 dB)
Low cutoff -6dB
55 Hz
High cutoff -6dB
23 kHz
SPL
Peak SPL
≥107 dB
Maximum peak acoustic output per pair, at 1 m distance with music material.
Short term max SPL
≥100 dB
Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz.
Long term max SPL
≥94 dB
Maximum long term RMS acoustic output in same conditions with IEC weighted noise (limited by driver unit protection circuit).
Self-generated noise
Self-generated noise
≤5 dB
Self generated noise level in free field on axis (A-weighted).
Weight
Weight3.2 kg (7.1 lb)
Dimensions
Height
230 mm (9 1/16 in)
Height with Iso-Pod
242 mm (9 17/32 in)
Width
151 mm (5 15/16 in)
Depth
142 mm (5 19/32 in)
Enclosure
Enclosure material
Die cast aluminium
Enclosure type
Reflex port
Drivers
Driver type
Cone
Diameter
105 mm (4 1/8 in)
Driver type
Metal dome
Diameter
19 mm (3/4 in)
Directivity
Harmonic distortion
> 200 Hz ≤0.5 %
Group delay
The latency at high frequencies from the input to the acoustic output, measured in the analog input:
Extended Phase Linearity in GLM set to OFF
2.8 ms
In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.
Amplifier Section
Amplifiers
50 W Class D
50 W Class D
Mains voltage
100-240 VAC 50/60Hz
Power consumption
ISS Active
≤0.5 W
Idle
≤3 W
Full output
50 W
Signal processing section
Connectors
Input
Analog signal input connector XLR female, balanced 10 kOhm.
2 x Control
Two CAT5 (RJ45) GLM Network connectors for computer control using the Genelec Loudspeaker Manager (GLM) software.
Validate your login